P & P Technologies

Ver 3.97

Welcome to PPtech's Website

PPtech is based in Wigan, Gtr. Manchester U.K. and is a small business designing and making, bespoke hardware, electronics circuitry, software, and this also includes:
Electronics R&D developments.
PCB drawing.
Prototype assembly including surface mount by hand.

Software Development:-

I am a licensed G8 Radio Amateur and have a special interest in RF transmission and PCBs for this.
Website information:-
This website is based on W3 School's templates
and uses the help of LTC Clock's jQuery, Ajax and PHP code.
The schematic image below is for decoration only and drawn by me years ago,
The guy with glasses below is "Matt the Geek" and is licence free.
The only image I am not sure about is the nice animated key on this page. This has been around for many years, used by radio amateurs, and I now cannot identify the owner on the www. If you are please use the contact form, and if requested I can remove it. 15/5/23

Some people might recognise this as me a few (??) years ago

Most of the time I never took photographs of my work, so here, only a small representation is shown.

Automatic tester for development purposes of a full sequence gas control, interface is on a PC app.

Large PCB for a gas controller, for development of fuel cell technology. Mid. England University.

Below probe PCB used in a test fixture. This holds 15 daughter boards feeding the probes to program 30 Microchip PICs in one go.

Previous board populated with 15 daughter boards to program 30 product PCBs, N.B. the by-hand assembled surface-mount components.

TV type screen display of a measurement for production testing of mechanical switches.

PSU as seen in the previous photo.

PCB with 30 mains inputs to drive a display unit to show which event caused a lockout in a large greenhouse heating system.

Part of previous PCB showing the switch mode PSU. The IC is a Power Integrations TNY254.

Mains interruption tester for pre-compliance testing of products.

10.

This is what can be done when you have to! 2.5x2mm LLP VCNL3682S device.

11.

Bed-of-nails fixture for connecting ESP12-F module to Arduino tester.

12.

Prototype of hand held setting tool for a measuring system.

13.

Inside of previous remote. RF module is Hope RFM70 for WiFi.

14.

Hand assembled prototype with PIC24FJ128GB204.

15.

To be added.